Fish procedures
------------------

(1) For each pair of fish, pick wire of appropriate length (or make one).
    Mark cable number on wire.

(2) Put one of the 3/8" sleeves over each Y bundle.

(3) Twist wire connectors together 

    Four cases:

    Fish marked without '    Use side of Y with green wire
    ------------------------------------------------------
      Catfish, trout, Lobster
         Red tag    -> Green wire
         Green tag  -> Green-white wire
         Yellow tag -> White-brown
         Blue tag   -> Brown
      Bass
         Three together -> Green wire
         Yellow tag     -> Green-white wire
         Black tag      -> Brown
         No tag         -> White-brown

     Fish marked with '     Use side of Y with blue wire
    ------------------------------------------------------
      Catfish, trout, Lobster
         Red tag    -> Orange wire
         Green tag  -> Orange-white wire
         Yellow tag -> White-blue
         Blue tag   -> Blue
      Bass
         Three together -> Orange wire
         Yellow tag     -> Orange-white wire
         Black tag      -> Blue
         No tag         -> White-blue

(4) Use battery pack to test function by cable wire color
    -------
    Trout, catfish
     Green +, Green/white  -    Tail flap
     White/brown +, Brown  -    Mouth

    Bass
     Green  +
     White/green -    Head out
     Brown       -    Tail flap
     White/brown -    Mouth

    --------
    Trout, catfish
     Orange +, Orange/white  -    Tail flap
     White/blue +, Blue  -    Mouth

    Bass
     Orange  +
     White/orange -    Head out
     Blue         -    Tail flap
     White/blue   -    Mouth

(5) Solder all connections. Don't leave too much bead

(6) Heat shrink 1 inch pieces over solder connections.
   Use cardboard as heat shield.

(7) Heat shrink 3" piece over all other connections.

(8) Use wire ties for strain relief

(9) Feed wires to trunk.